Removes Fuel Injector Deposits

Most new engines feature gasoline direct-injection (GDI) to boost power and improve fuel economy. These injectors are located inside the intense heat and pressure environment of the combustion chamber, making them particularly vulnerable to deposits. Extreme pressure combined with incomplete fuel combustion can lead to dramatically increased soot (particulate matter) levels. Direct injection typically creates 30 to 40 times more soot than port fuel injectors (PFI). Even a minimal amount of injector fouling can lead to increased pollution and wear and decreased power and fuel economy.

P.i. removes stubborn deposits and keeps injectors functioning as they should. Testing shows P.i. restored GDI fuel injectors to a 100% low rate after one tank of fuel.

Restores Horsepower

We set out to once again demonstrate the superior performance of P.i. through third-party testing using a 2016 Chevrolet Silverado with 100,616 miles on the odometer. Prior to testing, the truck was run on a chassis dyno and horsepower was measured. The 5.3L GDI engine was then disassembled, photographed and reassembled. Following a single tank of of fuel treated with P.i. driving at highway speeds, the truck was again strapped to the dyno. It measured an incredible 14% improvement in horsepower. The engine was then disassembled once again to see the impact P.i. had on deposits. The images to the right demonstrate the powerful cleaning performance of P.i on injectors and cylinder heads to signiicantly restore power and eficiency.

Fights Intake Valve Deposits

Valve deposits alter or restrict airlow patterns in the cylinder. They disrupt the balanced air/fuel ratio by momentarily absorbing and releasing fuel. The deposits can also cause valve sticking by getting in the way of the valve stem and guide.

P.i. helps keep valves clean and moving freely.

Cleans Combustion Chamber Deposits

Combustion chamber deposits increase compression and absorb heat during combustion. Later, they release that heat during the intake cycle. In some engines, deposits can cause the piston to actually hit the cylinder head – a process known as "carbon rap." The deposits can also lake off and become trapped between the valves and valve seat, resulting in compression loss.

Higher compression and stored heat increase the likelihood of pre-ignition “knock” when the fuel spontaneously combusts prior to spark ignition. This increases emissions and may cause engine damage. Most vehicles have sensors that adjust spark timing to prevent knock. Although audible “knock” is controlled, power is lost from retarded timing and engine eficiency suffers. Higher octane fuels can be used to help prevent the phenomenon. As a vehicle ages, more-expensive, higher-octane fuel is needed to keep it operating at peak performance.

P.i. fights combustion chamber deposits, which helps restore power, control knock, increase fuel economy and reduce the need for higher-octane fuels.

Capless-Compatible Packaging

Many new vehicles have replaced traditional fuel caps with capless systems. The threads on most bottles restrict them from opening the lap inside the fuel neck and also make removing the bottle difficult. The P.i. bottle is fully compatible with capless fuel systems.

GUARANTEED PERFORMANCE

Like our products, the AMSOIL Limited Warranty is built with an extra measure of protection. While some other oil companies guarantee their products only until you reach a specified mileage, we don't place restrictions on our warranty coverage based on total vehicle miles. 

We stand behind our products for as long as you use them!

Shop Now